A Bosch 4100 in a one-car garage

Start with the actual garage

The original review’s defining constraint was a one-car garage that still housed a car. The owner valued the rolling stand because it made moving the saw practical. That is a useful design brief for a small workshop: the routine of starting and finishing a session matters.

Sketch where the saw, car, bench and stored stock normally sit. Then draw a separate working arrangement. Check where the material will travel and where the support equipment will go.

Identify the stand separately

Bosch documents several stand models. The TS2100 product page lists compatibility with the 4100, but that does not identify the stand on your saw. Check its label before relying on mounting or operating instructions.

Bosch TS2100 information is a reference for that stand, not a claim that all 4100 packages include it.

A useful space checklist

Outfeed support is a separate decision

The original owner reported using an outfeed table or rollers for some long stock and sheet work. The lesson is to plan the surrounding setup rather than treating the saw table as the entire working surface.

Choose support that suits the operation and follows the relevant equipment instructions. We have not measured this garage or validated a new support design, so this guide does not prescribe a universal clearance or an untested folding-table plan.

Make the routine easy to repeat

Record the steps that make a short session cumbersome. Sometimes the next useful improvement is a place to store the hose or sled, not a different saw. See the dust-connection guide for one part of that routine.

If the working arrangement still cannot accommodate your regular projects, use the keep-or-replace guide to reconsider the workflow.